A biodegradable haze and image stain remover designed for a large variety of inks. This product contains corrosive material. Leave on screen five minutes or less.
This non-abrasive formula degreases new and used mesh and removes unwanted residue.
Imagemate 260 Degreaser
Specially formulated liquid to remove embedded U.V. and plastisol inks (haze and ghost images) that remain on the screen. Can be left on the screen longer than some of the more caustic haze removers.
Albatross Haze-Free Ghost & Haze Remover
CCI GB2000 Ghost & Haze Remover
Magic Mesh Prep
Specially formulated liquid to remove embedded U.V. and plastisol inks (haze and ghost images) that remain on the screen. Can be left on the screen longer than some of the more caustic haze removers.
Shelby's Haze Remover
Blockout Red 421 is an inexpensive, water-based solution used as a solvent-based ink barrier. This bright red liquid has just the right viscosity to spread easily on to every mesh count. Dry times have been greatly reduced with evaporating agents, yet is non-flammable. Water-soluble, therefore not for use with water-based inks.
Imagemate Blockout No. 421
Ulano Blockout No. 60
A water-soluble blockout with drying characteristics similar to Indirect Films.
Can be used full strength for touch-ups or thinned with water if desired. Can be used in unventilated rooms since it contains no organic solvents. Recommended for use on all fabrics, with all stencil systems. Use only with non-aqueous inks. Blue color.
An ultra fast drying (30 to 90 seconds), water soluble blockout. Recommended for on or off the press touch-up of direct stencil systems. Resists plastisol, UV, and most solvent based inks. Reclaims with water.
Blockout Pen
The abrading action of Ulanogel 23 promotes better wetting of the mesh and adhesion of the stencil, and thus, longer press life. Its degreasing action removes dirt, dust, and oils from the mesh, reducing the risk of stencil failure and pinholing.
Ulanogel 23 Roughening/Degreasing Gel
COMBINED LIQUID SCREEN DEGREASER, WETTING AGENT, AND ANTISTATIC TREATMENT
Magic Mesh Prep is a ready-to-use liquid combining the properties of mesh degreaser, wetting agent, and anti-static treatment.
Magic Mesh Prep improves the flow characteristics of liquids, facilitating more uniform coating of direct emulsions and the easier transfer of ink during printing, thereby improving printed image quality.
The improved wetting of mesh also promotes the adhesion of indirect and CDF® Direct-Film (capillary system film), and improves the durability of all stencil systems, for longer printing runs.
The antistatic properties of Magic Mesh Prep reduce the whiskering and feathering of ink when printing under low humidity conditions.
