For fast, easy, quality installation of graphics with no bubbles, even in cold weather.
Rapid Tac Application Fluid shocked installers by allowing them more control over their applications than ever before. Now what took hours could be accomplished in minutes. Using Rapid Tac Application fluid can often allow a large graphic to be installed with one person where two people were required to perform the same installation dry. Rapid Tac Application Fluid also cleans the substrate without leaving residues ensuring a contaminant free installation. It then helps to “float” the vinyl film until it is properly positioned. Rapid Tac Application Fluid’s best feature is that it effectively breaks the surface tension of the adhesive on the film allowing it to flow and bond to the substrate more effectively than even a dry application. It is now possible to achieve a full bond in as little as ninety seconds. Your customers and your reputation will benefit from higher-quality applications. Your bottom line will benefit from faster applications and less failures as well.
For removing adhesives quickly without damage or mess. The original Adhesive Remover.
How about saving some more labor hours? Rapid Remover is a guaranteed labor-saving product. To remove decals and vinyl from signs, windows, autos and many other substrates, many people are using lacquer thinner, MEK, acetone, paint stripper, grinders, etc., all of which are hazardous products. Experienced professionals start by using a heat lamp tree to soften vinyl. After peeling the vinyl off use Rapid Remover to easily remove the adhesive residue.
Rapid Remover is a non-toxic, water soluble adhesive remover that breaks down and removes most adhesives in 60 seconds! Spray it on, wait 30 to 60 seconds and easily wipe it off with a plastic squeegee, all with no damage to painted or bare metal surfaces. What may have been a four hour job (and a messy one at that) can now be done in less than half that time. Get the right tool for the job.